Developed with Triple K, who had no or many good things to fix the in-vehicle camera in the proper subtle position on the racing car's roll bar. Since it is anodized, it is a little expensive, but it can be fixed by high synthesis.
It was also possible to use the camera in upper and lower two stages in the test by removing one stage and shortening it and using it in the test.
It is recommended as a shooting accessory for shooting cameras such as GoPro and AIM DJI.
Possible pie system about 28.5mm to 50mm
Maximum total length about 43cm
Roll bar size can be installed by adjusting the screw from 28 pie to 50 pie.We recommend that only the fixed part be removed and the roll bar pad be turned for prevention of shaking.
The test was also used in RACING KART, but there was no problem with vibration.The multi clamp is D-cut so that the bottom does not rub against the road surface.
If it has a pipe, it is also recommended for photography such as bicycles and bikes.
For assembly and fixing, a 17mm spanner and 6mm hex wrench size are required.
Note: It needs to be fixed correctly.
It may not be available at races and events.You can not be held liable for any misuse, looseness, dropouts or accidents.Please use at your own risk.
Photo GoPro, camera base and mount are not included.
Tested race vehicle 86 / S2000 / Racing KART / Formula car
For races For races Race vehicles Motor sports Video shooting Film In-vehicle shooting On-board camera attachment Camera fixed Stay Mount
Two-stage extension flexible camera stay Roll bar fixed type (for pipes) In-vehicle camera On-board camera TripleK (Triple K)monocolle Collaboration items
To fix the in-vehicle camera firmly on the roll bar of the racing car at an appropriate delicate position was developed jointly with Triple K who had many inquiries without any good things. Ball joint processing, aluminum shaving, and alumite processing make it slightly higher, but it can be fixed with high synthesis.
In testing, it was possible to remove and use one stage, and to use the camera in two stages up and down.
Recommended as a shooting accessory for action cameras such as GoPro and AIM DJI.
Possible pie system About 28.5 pies to 50 pies
Maximum total length about 43cm
Roll bar size can be installed by adjusting the screw from 30 pie to 50 pie. In order to prevent shaking, we recommend that you remove the roll bar pad only from the fixed part and roll it.
I also used the test on RACING KART, but there was no problem with vibration. The multi clamp is D-cut so that the bottom does not rub against the road surface.
If it is a pipe, it is also recommended for shooting bicycles and motorcycles.
A 17mm spanner and 6mm hex wrench size are required for assembly and fixing.
Note: It must be fixed correctly.
May not be used in races and events. We do not accept any responsibility for incorrect use, looseness, dropouts, accidents, etc. Use at your own risk.
Photo GoPro, camera base and mount are not included.
Tested racing vehicles 86 / S2000 / Racing Kart / VITA / Formula Enjoy
For races For driving events For racing cars Motor sports Video shooting Film On-board shooting Onboard camera Attachment Camera fixing Stay mount
Camera stay for roll bar for GPS-NERO M & S cam SH-55 Accessories
2-stage extension flexible camera stay Roll bar fixed type (for pipes) In-vehicle camera Onboard camera TripleK
